Just following the directions. Be sure to select the correct bottom board (PDB), know which side is right-side-up, and notice arrow pointing forward.
Install set-screws in the 4 half-circle mounts, but leave them backed-off a bit so (closed-ends) bars slide easily for now. Use 8 proper screws to attach both under-carriages plates to hangers. Attach both of these carriage assemblies to bars before completely tightening the 8 screws that hold the half-circle mounts ( since the hangers are what determines the exact distance). I plan to slide bars out any time payload carriages or hangers need to be re-configured.
I assembled the landing gear, but left them un-attached from bottom PDB for now. Seems like it will be easier to solder ESCs onto board this way.
Next up ... installing ESCs. They should be here in a week or so. I think I will just edit and continue this post for a while.
إرسال تعليق