While my original Nova was one of the first off the assembly-line a year ago, this one has more updated-revision components.
Flight Controller: APM_252 v5.0 (now with pre-installed Molex Pico-Blade sockets for Telemetry, Compass, and Power-Module)
Power Distribution Board: v1.7
ESCs: 4x v1.6 (no sockets to PDB connection)
Compass: Original small one, hot-glued inside puck
GPS: Original (likely still an uBlox 6-series), on PDB
Looking forward to finally having a Power-Module on an aircraft and I'm hoping the barometer on this FC is more precise than my old one.
Compass socket came pre-bent (pulled-away from board) so I hope it's ok. Is still comes with special ArduCopter v3.1.2 pre-loaded. I pulled boards apart to check I2C port and general soldering. Not great but checks with ohm-meter. I installed black-tape insulation between USB-port case and lower PCB before re-assembling. General soldering on ESCs and stuff looks ok. I will fire it up soon and test log-memory, barometer, and general functions.
The supplied silver and black prop-nuts seem to be from a different vendor than old ones. They have more of a matte finish now. One of the new black ones starts to bind if tried to screw all the way down (without a propeller installed). However, it only happens on ONE of the CCW motors (not the other). That seems to point to a slightly out-of-spec motor thread. However, if replace both black ones with older (glossy finish) spares, binding goes away. Definite varying thread tolerances on both the motors and nuts ... might be why some people have "props-flying-off" problems at first.
As a quick test, I hooked up a X8R-RX, loaded some stock params from MissionPlanner, and got it to Arm. Motors seem to spin. Sensors seem to work. Logs (ram memory) are working. BEC is outputting 5.25volts under load. All looks good so I will start my mods and build-up (using tips I have learnt on first one).
Post a Comment